- Plug the transmitter into your vehicle’s socket or install the hardwired transmitter.
- Place units so that the charging ports are facing the center, toward each other.
- Turn on the units using the toggle-switch under the handle. The top ¾” LED on the inside of each unit will illuminate.
- Test the markers, left and right turn signals, and brake lights.
You cannot overcharge the battery in the light bar, so keep the bar on the charger when not in use. The batteries will resist developing a memory so you do not have to discharge them all the way. However, they must be charged on a regular basis to prevent them discharging to a very low voltage level. When charging, the green LED near the charge port will light. If the LED is not lit, check your connections to make sure that you are connected to full time power.
If you have any issues recharging the battery, plug the cigarette lighter adapter into the vehicle, but not into the light bar. If the LED on the cigarette lighter adapter is not lit, the fuse is most likely blown. Replace the fuse with a 5 amp fuse.
If you have further questions, please call 800-490-3158.